Swiss scientists have tested sheet metal safety using the CoaXPress Camera from SVS-Vistek.
In the drive to increase automobile fuel efficiency and reduce overall vehicle weight, sheet metal is recognized by engineers as an attractive candidate for fabricating auto components and structures. However, in order to maintain passenger safety, sheet metal’s response to the gross deformations that occur during forming and more importantly, crash events, needs to be fully understood.
To better study this issue, scientists at the Swiss Federal Institute of Technology in Zurich, Switzerland recently developed a novel axisymmetric V-bending device that identifies and measures the weakest direction of fracture strains in different types of sheet metal. “Plane strain” tension is one of the most critical loading conditions leading to ductile failure during metal forming and car crashes. Therefore, knowing the fracture strain and weakest orientation for stress is very crucial for the safe use of sheet metal in automobile design.
In most plane strain tension fracture experiments metals are tested in one orientation at a time, hence several experiments with different orientations have to be performed per test. This new approach developed by the Swiss Federal Institute of Technology tests all orientations simultaneously and determines the orientation with the lowest fracture strain under plane strain tension.
Using their new device, the scientists performed experiments on two widely-used aluminium alloys and two types of steel. Disc-shaped samples of the different metals were bent over a tubular knife with a diameter of 54mm. A 250kN electro-mechanical testing machine applied pressure load with a crosshead speed of 2mm/min.
To allow for Digital Image Correlation (DIC) necessary for analysis, a random pattern with a white background and black speckles was applied to the metals. An SVS-Vistek hr25CCX CMOS CoaXPress camera equipped with a 55mm f2.0 lens was used to take images of the test at 2 frames-per-second (FPS) and a spatial resolution of 14 μm/pixel. An LED ring light was mounted on the lens, evenly lighting the whole specimen surface during the experiment. Images from the experiments were post-processed with VIC-2D DIC software to measure in-plane full-field displacements and strains. Strain fields were computed using a Gaussian filter.
The SVS-Vistek camera took images of the entire top surface of the metal specimens throughout the experiment, allowing for timely crack detection and digital image correlation-based strain measurements. The setup probed all material directions in one single experiment and determined the least ductile material orientation for low strain, therefore saving time without compromising analysis quality.
Learn more about SVS-Vistek.
Also, stay up to date with the most recent machine vision and image processing news right here on MVPro Media.